Logo

B3429 BMW Fault Code

Check B3429 OBD Fault Code Reason
Description:

Variable Cam Timing Over-advanced (Bank 1) The comprehensive component monitor (CCM) monitors the VCT position for an over-advanced camshaft timing.
The test fails when the camshaft timing exceeds a maximum calibrated value or remains in an advanced position.

BMW cam timing improperly set No oil flow to the VCT piston chamber Low oil pressure VCT solenoid valve stuck closed Camshaft advance mechanism binding (VCT unit) B3429 DTC is a check of the VCT unit.

B3429 Code Symptoms :

See B3429 in engine

When you turn on the ignition, the Service Engine Soon or Check Engine B3429 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the B3429!

Diagnosis And Repairing B3429

B3429 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix B3429 code ?

See B3429 repair manual
  • Erratic camshaft position due to low oil pressure
  • Faulty Intake Valve Timing Control Solenoid Valve
  • Failures of clutch motion/travel sensors.
  • Faulty starter motor

Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

BMW Cars that meet B3429 error